モデルショップPAPA

在庫が無い場合は取り寄せになりますので在庫確認後に購入手続きをお願い致します。
品切れ時は為替レートの関係で価格が変更になる場合もあります。

M4系やHK416系の銃をピストルカービン化する際には必須アイテムです。
滅多に入荷しないシロモノなのでこの機会に是非どうぞ。。。

The Mil-Spec Enhanced buffer tube is an impact-extruded 6061 aluminum version of the PWS 416 Enhanced Buffer Tube. This version was designed as a more cost effective alternative to the original.

The PWS Enhanced Buffer Tube is the first major upgrade and improvement to the buffer tube in years!

Unlike the original PWS EBT, this unit is made from impact extruded 6061 aluminum in order to keep the cost down while keeping the quality high. The Enhanced Buffer Tube will resolve any carrier tilt symptoms exhibited by a short stroke piston AR and will reduce felt recoil.

The most notable features on this buffer tube include:

One piece construction eliminating the castle nut and ensuring that when installed, the buffer tube cannot become loose.
Attachment system automatically indexes the buffer tube perfectly straight.
The bottom of the interior buffer tube extends a lip into the receiver, supporting the bottom rear of the bolt carrier, reducing the carrier tilt present in some piston systems.
A dead blow buffer is securely installed in the rear of the buffer tube to reduce carrier speed by an average of 10%, and dramatically reduce felt recoil.
Two QD sling swivel attachments are machined into the front of the buffer tube allowing ambidextrous connection of your QD slings.
The buffer tube is fluted to allow debris to be pushed out of the way, and a drain hole has been placed in the bottom of the tube, allowing for draining of water when the rifle is parallel to the ground.

The PWS Enhanced Buffer Tube is made to accept Mil-Spec stocks.

Usage:
For use on AR-15/M16 based lower recievers and/or weapons platforms where a pistol setup is needed.

Specifications:

Length
7.75" (19.68 cm)

Diameter
1.15" (2.9 cm)

Width
1.8" (4.5 cm) at QD points

Weight
5.4 oz (144 grams)